Signs a lock is done
- The key has to be jiggled to turn
- The knob or lever is loose or droops
- The deadbolt only throws if you lift the door
- The finish is worn through to bare metal
- It was pried, kicked or tampered with
- It's a builder-grade lock on an exterior door

What we install
Entry sets. Knob or lever sets for front, side and back doors, usually paired with a separate deadbolt.
Deadbolts. Single cylinder for most doors. Double cylinder only where it's appropriate and allowed, because a deadbolt that needs a key inside can slow down an exit in a fire.
Handlesets. The tall decorative handle common on colonials in Andover and Chelmsford, with a matching deadbolt.
Mortise locks. Found in older Lowell and Haverhill homes and many commercial doors. We repair them or fit replacements so you can keep the door.
Fit matters more than brand
A good lock installed badly works worse than a cheap one installed well. We check the backset and bore size, line up the latch with the strike, and adjust the strike plate so the door doesn't need slamming. On older doors, we may fill and redrill holes so the new hardware sits tight.
Bring your own, or pick from ours
We carry common residential locks in the van. If you already bought hardware, we'll install it, as long as it fits the door. We can also key every new lock to match the others in the house, or to the key you already use. See rekeying for how that works.
Lock installation is available in Andover, Lowell, Methuen and every town on our service areas page.
Should I replace or just rekey?
If the lock works well, rekey. If it's worn, damaged or low quality, replace it.
Can you match my existing finish?
Usually. Tell us the finish when you call so we bring the right one.
